QWinOut OPLINK Mini CC3D Universal Transceiver TX RX Module Integrating Remote Controller PPM Input DIY FPV Drone

QWinOut OPLINK Mini CC3D Universal Transceiver TX RX Module Integrating Remote Controller PPM Input DIY FPV Drone

Click Here !!

If you are seeking Cheap Remote Control Helicopter then nowadays you are in the appropriate website.
QWinOut OPLINK Mini CC3D Universal Transceiver TX RX Module Integrating Remote Controller PPM Input DIY FPV Drone is one of the Cheap Remote Control Helicopter in the marketplace. This Great goods brings to you to satisfy your needs.
Here, we provide for you several of Cheap Remote Control Helicopter.

QWinOut OPLINK Mini CC3D Universal Transceiver TX RX Module Integrating Remote Controller PPM Input DIY FPV Drone

• Open Source Flight Controller Does Not Provided One By One Full Technical Guidance
• - 3 Io Ports: Micro-b USB, Mainport & Flexiport
• The Oplink Module Will Get It's Power From The Flight Controller's External Power, So Unlike Revolution, The Modem Will Not Get Powered On By Just Plugging In The USB To The Flight Controller.
• Make Sure That You Have The Same Openpilot Firmware Versions On Both The Flight Controller And Oplink Modem.
• Package Includes: - OPLM Radio Transceiver x 1 - Nessary Cables x 1set

Oplink Mini:
- 100mw Standalone Radio Modem
- 3 Io Ports: Micro-b USB, Mainport & Flexiport
- MMCX Antenna Connector.
- Weight: 4g
- Dimensions: 20mm x 29mm
- Input Voltage: +5v

Package Includes:
- OPLM Radio Transceiver x 1
- Nessary Cables x 1set
 
Summary: 
This Page Will Walk You Through How To Set Up The Hardware Connections That Are Required For Coptercontrol, Cc3d And Atom Oplink Operation. All Openpilot Boards Support Connection With The Oplink Module. The Oplink Connection Can Be Used For Telemetry And/Or Vehicle Control. 
The Oplink Module Will Get It's Power From The Flight Controller's External Power, So Unlike Revolution, The Modem Will Not Get Powered On By Just Plugging In The USB To The Flight Controller. Make Sure That You Have The Same Openpilot Firmware Versions On Both The Flight Controller And Oplink Modem. All The Examples Below Are Shown With a Cc3d Flight Controller Board, But The y Can Be Applied To Coptercontrol And Atom, Also.
Hardware Connections
Telemetry Only
The Oplink Will Be Set Up to Talk Bidirectional Telemetry with The Flight Controller. You Can Use a Regular Openpilot 4-Pin JST SH Cable To Connect The Two Boards. It is Recommended To Use Main Port for Both Boards, But You Can Also Use Other Ports To Connect Telemetry. Just Remember The Changes In The Configuration Steps Below.

Check Price & More Information >>>

Product prices and availability are accurate as of the date/time indicated and are subject to change. Any price and availability information displayed on this site at the time of purchase will apply to the purchase of this product.